« Sigmetrix CETOL Does Tolerance Analysis with SolidWorks | Main | Sheet Metal Prototypes with Free SolidWorks Add-in from Rapid Sheet Metal »

February 15, 2014



There is no proper manual at all available to work with Smap-3D in Solidworks!
This sucks a lot!

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name is required. Email address will not be displayed with the comment.)