« Breault Research (BRO) APEX Does Optical Design Inside SolidWorks | Main | CAMWorks Recommended for SolidWorks Users »

February 11, 2014

CAL Calculates Sheet Metal Bends

Logo_cal

Best-of-showSAN DIEGO, CA (SolidWorks World 2014) - CAL is a SolidWorks add-in for bend sheet metal bend calculation, mmade by Orbit Technology, and was being shown by La Boschiny, Inc. at the show. You can quickly and easily lay out sheet metal parts and determine if they can be bent. Cost is $5,100.

http://www.caleasytouch.com/solidworksaddin.html 

TenLinks Show Judge

Mcelyea_l

Bryan McElyea

Posted at 04:11 PM in CAM, SolidWorks, SOLIDWORKS World |

Comments

Verify your Comment

Previewing your Comment

Posted by:  | 

This is only a preview. Your comment has not yet been posted.

Working...
Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.

Working...

Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name is required. Email address will not be displayed with the comment.)