« Siemens PLM Promises Support of Solid Edge... Again | Main | Solid Edge 'Adopt a School' Aims High »

June 27, 2011


Junxiong Lei

Good work. Thanks, Mark!

Jon Banquer

I believe it Mark. I truly do but they don't. :( This is what you are going to be fighting against.

I honestly think the best thing to do is get NX CAM to run directly inside of Solid Edge ST's user interface. This is where you should focus your effort. Major adoption problem with NX CAM is the user interface. Give it Solid Edge ST's user interface and you've got a powerful package that most others would have a very difficult time competing with.

You need to get this done and do whatever it takes to get it done.

Jon Banquer
San Diego, CA



Let me say right now that its a level playing field. If more CAM companies want to partner with Solid Edge (and I hope they do) I'll be glad to help them do it.


Jon Banquer

The problem is and continues to be fully integrated CAM for Solid Edge and this problem has only gotten worse in the last two years.

Mark Burhop should be focused on getting Siemens NX CAM developers to port NX CAM to the Solid Edge ST user interface because the 3rd party CAM vendors that I've spoken with are all afraid that they will end up competing with NX CAM if they port to Solid Edge ST. Further, they would rather focus on SolidWorks and Autodesk Inventor because they have a much bigger market share than Solid Edge ST does.

It's going to take a lot of work to convince Tony Affuso that NX CAM needs to be ported to the Solid Edge ST user interface. I wish Mark lots of luck with that because he's going to need it! I don't think you could pay me enough money to try and accomplish this next to impossible job that Mark is now tasked with. :(

Jon Banquer
San Diego, CA

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name is required. Email address will not be displayed with the comment.)